Table of Contents
Advertisement
Water Filter
By-pass Cover
To fit the water filter follow the instructions
below referring to figures supplied:
1.
Take out the upper salad crisper in the
fridge as shown in the figure below.
2.
Unscrew the water filter by-pass cover.
Caution:
Make sure that the Ice off mode
is active before taking out the by-pass cover.
Note:
It is normal that a few drops of water
drip after the cover has been taken out.
3.
After removing the red cover on the head
of the water filter, install it as shown in the
figure below.
4.
Press Ice Off button on the display again
to exit from this mode.
Water filter should be replaced every 6
months. Water filter replacement warning will
1
appear on the screen after about 6 months.
The warning light will remain on for about 15
days before it starts to flash. Once the filter
has been replaced, this warning light can be
cancelled by pressing the Eco Extra button
on the display for 5 seconds.
The water filter must be removed as shown
in the figure when it is going to be replaced
or when it will no longer be used. Make sure
that the Ice off mode is active before removing
the water filter.
If you do not want to use the water filter,
warning light should be cancelled. To do this,
"Freezer Set" and "Water/Ice Type Selection"
buttons must be pressed simultaneously for
2 seconds. Filter warning will flash for 5 times
when pressed in this way and the warning
will be cancelled. Filter warning will flash for
10 times when the same buttons are pressed
2
EN
12
Water Pipe
Bypass Cover
REMOVE
3
Water Pipe
Filter
LOCK
Hide quick links:
Advertisement
Table of Contents
