Guided Tour - Cr77 Receiver - Samson AirLine 77 Owner's Manual

Samson AirLine
ANT. A
-20
ANT. A
VOLUME
2: Volume control - This knob sets the level of the audio signal being output through both the balanced and unbalanced output jacks on
the rear panel (see #2 and #4 on page 8 in this manual). Reference level is obtained when the knob is turned fully clockwise (to its "10" set-
ting).
3: Audio Meter - - This "ladder" display (similar to the VU bar meter used on audio devices) indicates the strength of the incoming audio
signal. When the "0" segment is lit, the incoming signal is optimized at unity gain; when the "+6" segment is lit, the signal is overloading.
When only the left-most "-20" segment is lit, the incoming signal is at just 10% of optimum strength. If no segments are lit, little or no signal
is being received. See the "Setting Up and the AirLine System" section on page 16 in this manual for more information.
Guided Tour - CR77 Receiver / Front Panel
-10 -5 0 +3 +6 0 10 25 50 75 100
AUDIO METER dB RF METER
CR77 UHF TRUE DIVERSITY RECEIVER
1: Antennas (A and B) - The anten-
na mountings allow full rotation
for optimum placement. In normal
operation, both Antenna A (the
antenna on the left) and Antenna
B (the antenna on the right) should
ANT. B
be placed in a vertical position.
Both antennas can be folded inward
for convenience when transporting
ANT. B MIN MAX
the CR77. See the "Setting Up and
SQUELCH POWER
Using the AirLine System" section on
page 17 in this manual for informa-
tion about antenna installation and
positioning.
6