Table of Contents
Advertisement
Cable lock slot
Setting up your monitor
Connecting and turning on your monitor
Your monitor is equipped with a cable lock slot located on the rear of your monitor (in
the lower position). Please see the instructions that come with the cable lock to learn
how to using it.
This section provides information on how to set up your monitor.
Note: Be sure to read the Safety information located on page iii before carrying out
this procedure .
1.
Power off your computer and all attached devices, and unplug the computer
power cord.
2.
Connect the analog signal cable to the VGA connector of the monitor and the
other end on the back of the computer.
Place the cable into the cable clip indicated in below figure.
3.
Connect the digital cable to the DVI connector of the monitor and the other end
on the back of the computer.
Place the cable into the cable clip indicated in below figure.
Chapter 1.
1-3
Advertisement
Table of Contents
