Maytag MDE17PR Installation Instructions Manual page 23

CODE
COIN SLIDE OPTION
8.00
This option is either SELECTED 'ON' or NOT SELECTED 'OFF'.
8.00
Not Selected 'OFF'.
Selected 'ON'.
8. CS
Press the DELICATES key pad 3 consecutive times for this
selection. When coin slide mode is selected, set 'b.' equal to
value of slide in nickels. Set '606' (REGULAR CYCLE PRICE)
and '3.06' (SPECIAL CYCLE PRICE) to number of slide
operations.
NOTE: If the installer sets up 'CS' on a coin drop model, it will
not register coins.
Press the PERM. PRESS key pad once to advance to next code.
ADD COINS OPTION
E . 0 0
This option is either SELECTED 'ON' or NOT SELECTED 'OFF'.
This option causes the customer display to show the number
of coins (coin 1) to enter, rather than the dollars-and-cents
amount.
E . 0 0 Not Selected 'OFF'.
Selected 'ON'. Press the DELICATES keypad 3 consecutive
E . A C
times for this selection.
PR MODELS ONLY: In enhanced debit mode, this option is
not selectable.
Press the PERM. PRESS key pad once to advance to next code.
J . C 8
COIN/DEBIT OPTION
J . C 8
Both coin & debit selected.
J . C 8
Coins selected, debit disabled.
Press DELICATES key pad for this selection.
Debit Card selected, coins disabled. Press DELICATES
J . C 8
key pad for this selection.
Enhanced Debit is self-selected when a Generation 2 card
J . E 8
reader is installed in the dryer. The 'Ed' option cannot be
manually selected or deselected.
Press the PERM. PRESS key pad once to advance to next code.
L . 0 0
PRICE SUPPRESSION OPTION
This option is either SELECTED 'ON' OR NOT SELECTED 'OFF'.
This option causes the customer display to show 'AVAILABLE'
or 'ADD' rather than the amount of money to add. (Used
mainly in debit installations.)
L . 0 0
Not Selected 'OFF'.
L . PS
Selected 'ON'. Press the DELICATES key pad once for this
selection.
Press the PERM. PRESS key pad once to advance to next code.
8. C E
CLEAR ESCROW OPTION
This option is either SELECTED 'ON' OR NOT SELECTED 'OFF'.
When selected, money held in escrow for 30 minutes without
further escrow or cycle activity will be cleared.
8. C E
Selected 'ON'.
8.00
Not selected 'OFF'. Press the DELICATES key pad once for this
selection.
Press the PERM. PRESS key pad once to advance to next code.
0. 0 0
PENNY INCREMENT OFFSET
0. 0 0
This represents the penny increment price offset used in
Generation 2 (Enhanced Debit) PR models. Choose from 0-4
pennies by pressing the WHITES AND COLORS key pad.
Press the PERM. PRESS key pad once to advance to next code.
EXPLANATION
If cycle counter (9.0C) is selected, the following is true:
100 Represents the number of cycles in HUNDREDS. 1 02 = 200
200 Represents the number of cycles in ONES.
This is "VIEW ONLY" and cannot be cleared.
Press the PERM. PRESS key pad once to advance
to next code.
If money counter (1.0C or 1.C0) is selected, the following is true:
300 Number of dollars in HUNDREDS.
400 Number of dollars in ONES.
500 Number of CENTS.
END OF SET-UP PROCEDURES
EXIT FROM SET-UP MODE
SINGLE LOAD PD MODELS: Reinstall access door.
I
SINGLE LOAD PR MODELS:
I
Unplug dryer or disconnect power.
Open console, reinsert plug into AA1, close console.
Plug in dryer or reconnect power.
DIAGNOSTIC GUIDE
If the set-up mode is entered and one of the following has occurred,
the appropriate diagnostic code will be in the display.
SINGLE DRYERS
CODE
Dryer door sense error on control board or due to
d 1
power line interference (cycles and price display
disabled until diagnostic code is manually cleared).
Dryer motor control circuit error (cycles and
d 4
customer display disabled until diagnostic code is
manually cleared).
Blocked coin 1 or coin drop control circuit failure
d 5
(coin recognition and customer display disabled
while blockage persists).
d 9
Voltage detected below 90 VAC for 8 seconds.
Motor sense error on control board or due to power
d 12
line interference (cycles and customer display
disabled until diagnostic code is manually cleared).
Blocked coin 2 or coin drop control circuit failure
d 13
(coin recognition and price display disabled while
blockage persists).
d 16
Not receiving communications from installed debit
card reader in Enhanced (Generation 2) Debit mode.
2 25 = 225
TOTAL = 225
cycles
3 01 = $100.00
4 68 = $168.00
5 75 = $100.75
TOTAL = $168.75
EXPLANATION
23