Enabling Or Disabling A Device; Selecting A Startup Device; Selecting A Temporary Startup Device - Lenovo ThinkCentre 7522 User Manual

Enabling or disabling a device

This section provides information on how to enable or disable user access to the
following devices:
SATA Controller
Floppy A
To set the SATA Controller, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on
2. From the Setup Utility program menu, select Devices → ATA Drives Setup →
3. Select the desired settings and press Enter.
4. Return to the Setup Utility program menu and select Exit → Save Changes and
To set the Floppy A, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on
2. From the Setup Utility program menu, select Devices → Floppy Drive Setup →
3. Select the desired settings and press Enter.
4. Return to the Setup Utility program menu and select Exit → Save Changes and

Selecting a startup device

If your computer does not start up from a device such as the disc, diskette, or hard
disk drive as expected, do one of the following to select the startup device you
want.

Selecting a temporary startup device

Use this procedure to start up from any startup device.
Note: Not all discs, hard disk drives, and diskettes are bootable.
To select a temporary startup device, do the following:
1. Turn off your computer.
2. Repeatedly press and release the F12 key when turning on the computer. When
3. Select the desired startup device from the Startup Device Menu and press
When this feature is set to Disabled, all devices connected to the
SATA connectors (such as hard disk drives or the optical drive)
are disabled and will not be displayed in the system
configuration.
When this feature is set to Disabled, the diskette drive cannot be
accessed.
page 49.
SATA Controller.
Exit.
Note: If you do not want to save the settings, select Discard Changes and Exit.
page 49.
Floppy A.
Exit.
Note: If you do not want to save the settings, select Discard Changes and Exit.
the Startup Device Menu opens, release the F12 key.
Enter to begin.
Chapter 4. Using the Setup Utility
51