Memorex MPH 6988 Manual page 38

Color profile: Disabled
Composite Default screen
I.C. NOTICE
"Notice: The Industry Canada label identifies certified equipment. This certification means that
the equipment meets certain telecommunications network protective, operational and safety
requirements. The Department does not guarantee the equipment will operate to the user's
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the
facilities of the local telecommunications company. The equipment must also be installed using an
acceptable method of connection. The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications company cause to request the user to
disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power
utility, telephone lines and internal metallic water pipe system, if present, are connected together.
This precaution may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or electrician, as appropriate."
"Notice: This cordless telephone uses radio communications between the handset and the base
set, and may not ensure privacy of communication. Other devices including other cordless
telephones may interfere with the operation of this cordless telephone or cause noise during
operation. Units not containing coded access signaling could be accessed by other cordless
telephones or radio communications systems. Cordless telephones must no cause interference to
any licensed radio service."
"Note: Operation is subject to the following conditions: 1) This device may not cause interference,
and 2) This device must accept any interference, including interference that may cause undesired
operation of the device."
Notice: The Load Number (LN) assigned to each terminal device denotes the percentage of the
total load to be connected to a telephone loop which is used by the device, to prevent overloading.
The termination on a loop may consist of any combination of devices subject only to the
requirement that the sum of the Load Numbers of all the devices does not exceed 100.
Load No.: See label on base unit bottom.
Privacy of communication may not be ensured when using this device
38
I:\Mph6988 second lot\MPH6988 OM.vp
Thu Jul 29 17:10:43 1999