First Time Setup - Panasonic TC-P58V10X Operating Instructions Manual

First Time Setup

"First time setup" is displayed only when the TV is turned on for the first time after the power cord is
inserted into a wall outlet and when "Auto power on" (p. 36-37) is set to "No".
or
■
Press to exit from
a menu screen
■
Press to return
to the previous
screen
16
Turn the TV On with the POWER button
or
(TV) (Remote)
* This setting will be skipped next time if you select "Home Use".
Select your language
Language
English Español Français
Be sure to select "Home Use"
Please select your viewing environment
Home Use Store Demonstration
Select "Home Use" when using this TV in your home.
Please confirm your selection (Home Use) before pressing OK button.
■
If you select "Store Demonstration" by mistake in ,
confirmation screen will be displayed.
You are selecting the mode for store demonstration
Yes No
If you select "Yes", the picture mode will regularly reset
to "Vivid" and a Picture Refresh message will be
displayed on the screen.
Select "No" and return to previous screen
If you select "Yes", Screen enters store demonstration mode.
To display the "Please select your viewing environment" screen again as
shown above and select "Home Use", do one of the following:
• Press and hold down the front POWER button.
• Unplug the TV and plug it again.
Auto channel setup
Select "ANT/Cable setup"
First time setup
Language
ANT/Cable setup
Network setting
VIERA CAST setting
Clock
Input labels
Select "ANT in"
ANT/Cable setup
Cable
ANT in
Auto program
Select "Not used" when no wire is connected to the "Antenna/Cable" terminal.
Typical when Cable/Satellite box is connected to a TV input.
Prevents accidental tuning to an unavailable signal.
select
ok
select
ok
select
ok
.
next
select
ANT in
set
Cable: Cable TV
Antenna: Antenna
Not used: Skip TV tuning
select
go to