Table of Contents
Advertisement
USER MAINTENANCE INSTRUCTIONS
To prevent trouble and poor operating, it is important to check filters and spray arms
at regular intervals.
Keeping the dishwasher
• If you are not using the dishwasher for a long
time, run a Quick & Dry cycle without detergent.
When the cycle is finished, clean the dishwasher
according to the USER MAINTENANCE
INSTRUCTIONS to remove the food debris at
the bottom of the dishwasher and close the door.
Filters
• Remove the lower rack first.
• Turn the mesh filter counterclockwise.
• Take out the mesh filter, upper STS filter and
outer filter.
• We recommend to clean them and run the Quick &
Dry cycle without detergent at least once a week.
• Replace them in the reverse order.
NOTE
• After each cycle, clean the filter for a better
washing result.
• Before starting, check that the filter is
assembled well. If the filter is not assembled
correctly, you might have a poor cleaning
result.
Lower Spray Arm
• Check that the water jet holes are not blocked.
• If cleaning is required, remove the arm by
pulling up.
• Clean the spray arm and replace it pulling down.
Upper Spray Arm
• Pull the upper rack forwards.
• Check that the water jet holes are not blocked.
• If cleaning is required, remove the arm by
unscrewing the nut.
• Clean the spray arm and replace it in the
reverse order.
Water Inlet
Mesh filter
• A filter is incorporated in the connection of
the valve on the water inlet hose.
If insufficient water flows into the dishwasher,
Outer filter
check that the filter is not blocked.
• Cleaning the filter
Upper STS
- Disconnect the dishwasher
filter
from the mains supply.
Switch off at the mains
socket and remove the plug.
- Turn off the tap.
- Unscrew the inlet hose.
- Remove the filter from
connection.
- Clean the filter in the supply
hose under running water.
- Refit the filter, making sure
it is sitting correctly.
- Reconnect the inlet hose to the tap.
- Turn on the tap.
• If there is a leak, the inlet hose might not be
on securely, or it may have been screwed on
at an angle. Unscrew and reconnect the water
inlet valve correctly.
• Reconnect power supply.
30
30
Advertisement
Table of Contents
