Setting Up The Projector; Adjusting The Projector's Elevator Feet - ViewSonic pj650 User Manual

Setting up the projector

CAUTION
• Install the projector in a suitable environment according to instructions of the accompanying manual
"PJ650 / PJ520 Quick START GUIDE" and this manual.
• If you press the elevator buttons without holding the projector, the projector might crash down, overturn,
smash your fingers and possibly result in malfunction. To prevent damaging the projector and injuring
yourself, ALWAYS HOLD THE PROJECTOR whenever using the elevator buttons to adjust the elevator
feet.

Adjusting the Projector's Elevator Feet

You can use the elevator feet to make adjustments if the surface on which you need to set the projector is
uneven or if you otherwise need to adjust the angle of projection. The adjustment range of the elevator feet is
0 to 9 degrees.
1 Press and hold in the elevator buttons.
2 Raise or lower the projector to the desired height and
then release the elevator buttons.
When you release the elevator buttons, the elevator feet
will lock into position.
3 As necessary, you can also finely adjust the height of
the projector by twisting the elevator feet by hand.
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
ViewSonic PJ650/PJ520 6