Table of Contents
Advertisement
"BRAVIA" Sync ([Control for HDMI])
Symptom
The [Control for HDMI]
function does not work
("BRAVIA" Sync).
Network connection
Symptom
The system cannot connect to the
network.
USB wireless LAN connection
Symptom
You cannot connect your PC to
the Internet after [Wi-Fi
Protected Setup (WPS)] is
performed.
You cannot connect the system
to your wireless LAN router.
The desired wireless router is not
detected even if [Scan] is
performed.
The system cannot connect to the
network or the network
connection is unstable.
70
GB
Problems and solutions
• Check that [Control for HDMI] is set to [On] (page 60).
• If you change the HDMI connection, turn the system off and on again.
• If power failure occurs, set [Control for HDMI] to [Off], then set [Control for
HDMI] to [On] (page 60).
• Check the following and refer to the operating instructions supplied with the
component.
– the connected component is compatible with the [Control for HDMI]
function.
– the connected component's setting for the [Control for HDMI] function is
correct.
Problems and solutions
• Check the network connection (page 24) and the network settings (page 61).
Problems and solutions
• The wireless settings of the router may change automatically if you use the
Wi-Fi Protected Setup function before adjusting the settings of the router. In
this case, change the wireless settings of your PC accordingly.
• Check if the wireless LAN router is on.
• Depending on the usage environment, including the wall material, radio wave
reception conditions, or obstacles between the system and the wireless LAN
router, the possible communication distance may be shortened. Move the
system and the wireless LAN router closer to each other.
• Devices that use a 2.4 GHz frequency band, such as a microwave, Bluetooth, or
digital cordless device, may interrupt the communication. Move the unit away
from such devices, or turn off such devices.
• Press RETURN to return to the previous screen, and try [Scan] again. If the
desired wireless router is still not detected, press RETURN to select [Manual
registration].
• The distance between the unit and the wireless LAN router is too far (page 24).
Advertisement
Table of Contents
