Step 2: Connecting The System - Sony BDV-E985W Operating Instructions Manual

Step 2: Connecting the System

For connecting the system, read the information on the following pages.
Do not connect the AC power cords (mains leads) of the unit and surround amplifier to a wall outlet
(mains) until all the other connections are made.
To assemble the speakers, refer to the supplied "Speaker Installation Guide."
• When you connect another component with a volume control, turn down the volume of the other components to a
level where sound is not distorted.
Connecting the speakers
To connect speaker cords to the speaker
You need to connect a speaker cord to each of the front, center, and surround speakers.
The connector of the speaker cords and the color tube are color-coded based on the speaker type.
Be sure to match the speaker cords to the appropriate terminals on the speakers: the speaker cord with
the color tube to 3, and the speaker cord without the color tube to #. Do not catch the speaker cord
insulation (rubber covering) in the speaker terminals.
Connector
To connect speaker cords to the unit and surround amplifier
Connect the speaker cords to match the color of the SPEAKERS jacks of the unit and surround
amplifier.
When connecting to the unit and surround amplifier, insert the connector until it clicks.
White
(Front left
speaker (L))
Red
(Front right
speaker (R))
SPEAKERS
FRONT R
Rear panel of the unit
18
GB
Color tube
(+)
(–)
Purple
(Subwoofer)
Green
(Center speaker)
FRONT L SUBWOOFER CENTER
Rear or bottom of the speaker
Blue
(Surround left
speaker (L))
L
IMPEDANCE USE
SPEAKERS
Rear panel of the surround amplifier
Gray
(Surround right
speaker (R))
R
3-16