Sharp DK-CL8PH(BK) Operation Manual page 8

System connections (continued)
DK-CL8PH(BK)
DK-CL8PH(GR)
DK-CL8PH(PK)
■ Install/Replace batteries
For Backup battery:
Use 2 "AAA" size batteries (UM-4, R03, HP-16 or similar).
Batteries are not included.
1
Open the battery cover.
2
Insert the batteries according to the direction
indicated in the battery compartment.
When inserting or removing the batteries, push them
towards the
3
Close the cover.
8
battery terminal.
–
Notes:
●
The battery system is use to provide continuous clock backup
operation in event of a power failure. Please make sure the
AC/DC adaptor is connected, otherwise all setting may be
lost during battery replacement.
●
Remove the batteries if the unit will not be used for a long
period of time to prevent battery leakage which may cause
potential damage.
●
The first time power on unit, the clock will blinking on the
display. Please set the time and date (refer page 9).
Note:
Battery life may vary depending on the temperature, battery
types and usage conditions.
Precautions for battery use:
●
Installing the batteries incorrectly may cause the unit to
malfunction.
●
Insert the batteries according to the direction indicated in the
battery compartment.
●
Replace all old batteries with new ones at the same time.
●
Do not mix old and new batteries.
●
Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
Caution:
Do not use rechargeable batteries (nickeI-cadmium battery,
etc.).