Allows you to set the password for your system. When typing the
password, first make sure that
the entry fields and press
and pressing
Enter
enabled, the set password is always required to boot the computer.
SCU Password
Allows you to set the password for entering SCU Setup. When typing the
password, first make sure that
the entry fields and press
and pressing
Enter
SCU password is always required to enter SCU Setup.
Hard Disk Boot Sector
Sets if a warning message will appear when the hard disk boot sector
(partition table) has been changed. A checkmark ( ) indicates enabled,
while an underline (_) indicates disabled. The default setting is disabled.
CAUTION: Set this item to disabled before installing an operating system, running
Fdisk or Format program. Otherwise, the intended action will fail.
5-10
Num Lock
. Confirm your password by typing it again
Enter
. If the Enable Password to Power-on sub-item is
Num Lock
. Confirm your password by typing it again
Enter
. If the Enable SCU Password sub-item is enabled, the
is off, then type your password in
is off, then type your password in
Setup Configuration Utility (SCU)