Sony CX-J3000 Service Manual page 2

CX-J3000/J3000M
Power consumption
CX-J3000 a nd CX-J3000M ( Russian model):
70 watts
CX-J3000M ( Mexican model):
90 watts
CX-J3000M ( Chilean and Peruvian models):
100 watts
Dimensions (w/h/d) incl. projecting parts and controls
Amplifier/Tuner/Tape/CD section:
Approx. 270 × 300 × 294
mm
Mass
CX-J3000 and CX-J3000M (Russian model):
Approx. 4.8 kg
CX-J3000M (Mexican, Chilean and Peruvian models)
Approx. 5.5 kg
Design and specifications are subject to change
without notice.
2
All manuals and user guides at all-guides.com
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C
• Do not touch the soldering iron on the same conductor of the
• Be careful not to apply force on the conductor when soldering
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
damaged by heat.
during repairing.
circuit board (within 3 times).
or unsoldering.
This appliance is classified as
a CLASS 1 LASER product.
The CLASS 1 LASER
PRODUCT MARKING is
located on the rear exterior.
SAFETY-RELATED COMPONENT WARNING!!