Advertisement
Configuration
1.
Highlight the station in Design Center; click Configure
Stations.
2. Station displays configure mode and touch to configure.
3. When configured station goes back to ready until
programmed.
Device Settings
Device Settings are accessed through the Profile pages.
Widgets Overview
For detailed information about widgets, click on file to load Widget Instructions: Equinox Widgets_install.pdf (click to open)
©Vantage, 41551 / IS-0542-A / InFusion
4. The station may also be configured by typing the serial
1.
Press the profile button, (my home, upper right, in this example)
2. Press the settings button
3. Press the down arrow next to dashboard or swipe the screen left to device
4. Pressing the down arrow button in step 3, brings this screen. Select the
device button
The first time the controller is programmed, the Equinox 73 device should use
the brightness settings specified in the Equinox Widget Styles object in Design
Center. Subsequent system downloads depend on whether or not the Read and
Restore – Equinox Profiles and User Data is checked. When checked, it will retain
the brightness settings on the device. When unchecked, it will use the brightness
settings specified in the Equinox Widget Styles object in Design Center.
5.
The device screens are accessed by swiping up or down to see all of the
screen choices. The first device screen allows settings for:
brightness – brightness level for active and inactive modes
auto mode* – uses ambient light to adjust screen brightness
off when dark – when ambient light is very low the screen illumination turns off
system information – useful for diagnostics and general information
*auto mode:
auto mode calibration – these options only appear when the auto mode box is
checked.
low trim – (range 1%-25%) If screen is too dim when used in a dark room,
increase the low trim setting and conversely when screen is too bright.
Adjust – (range, -5 to +5) If screen is too dim when used in a moderately lit
room, increase the adjust setting and conversely when screen is too bright.
Adjustments take a few seconds for the screen brightness to change. This delay
action is deliberate to avoid sudden changes in screen brightness.
6. Scroll down to the next device screen for:
firmware version – connected: true (false)
app version – xx.xx.xx (used in diagnostics)
kernel version – version and date (used in diagnostics)
rootfs version – xx.xx.xx (used in diagnostics)
controller ip address – local controller's IP address to connect to
remote ip address – remote connection – typically not used with the
Equinox 73 station.
reconnect – forces attempt to reconnect to the InFusion system
7. Scroll down to the bottom of device screen:
reset user settings – clears the current IP information when the device
is restarted through power cycle or reboot method. (use reconnect
after using the reset button)
Equinox 73 LCD Touchscreen – MODEL: EQ73TB-TI
-OR-
number in the project file, using this method the station
will automatically be configured when the system is
programmed.
I N S T A L L A T I O N
page 2 of 3
Advertisement
