Quoizel TML8407K Assembly Instruction Sheet

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Bulb Recommended: (2) B10 Candelabra Base Bulbs 60W Maximum
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
Fixture can only be mounted in the direction indicated on page 2.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
Fixture
A Body
x 1
Hardware Contents
Inner Backplate
AA
x 1
-
STEP 1 Install Bulbs
A. Insert bulbs onto sockets and screw
snugly into place.
-
STEP 2 Attach Glass to Fixture
Body
A. Insert the Wider Glass (B) Panel
to the Cage close to the
backplate first. Then insert the
two Narrow Glasses C to the ( )
cage next to the installed wider
glass. Insert the other Wider
Glass (B) to the cage at last.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
2017 QuoizelInc.
Assembly Instruction Sheet #IS-TML8407K
for product cleaning tips. Go to the
30-45 minutes
Wide
B Glass
x 2
Mounting Screw
BB
x 2
Bulb (not
supplied)
Socket
Figure 1
A
B
Figure 2
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
For Style TML8407K
Care + Maintenance selection.
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
Narrow
connections. Twist connectors until wires are tightly joined together.
C Glass
Wrap each connection with approved electrical tape and carefully
x 2 stuff all the connected wires into the Outlet Box.
from outlet box
Black wire from
outlet box (or Red)
Bare, or Green
Ground wire
from outlet box
STEP 4 - Attach fixture to Inner
Backplate
A. Place the backplate of the
Fixture Body (A) onto the Inner
Backplate (AA). Line up holes
on both of them. Thread
Mounting Screws (BB) into the
mounting holes on the Inner
Backplate (AA) and hand
tighten until snug to secure
them.
STEP 5 - Apply Silicone Sealer
A. Make sure exterior wall surface
and fixture backplate are free of
dirt before applying caulk. Using
exterior grade caulk, caulk over
C
top of backplate and down other
side. Do not caulk bottom of fixture
backplate to ensure proper
B
moisture drainage.
C
Your fixture is now assembled and
ready to use. Enjoy!
1of2
White wire
Green Ground Screw
on the Crossbar
Mounting
Hole
AA
_R1
White wire
from fixture
Black wire
from fixture
Ground wire
from Fixture
Figure 3
BB
A
Backplate
Figure 4
Figure 5
Exterior
Grade
Caulk
Backplate
RevisedDate:2017-11-09