Download Print this page

Electrolux The boss 7106 Quick Start Manual page 4

Advertisement

Replacing the micro filter
Open the filter grill to remove the exhaust filter. (fig. 27)
Take the filter out of its place.
Put a new filter into its place, then close the filter grill.
Motor and microfilter reference number: UF71
OPERATING THE HOSE IN/OUT OF THE SUCTION INLET
To connect the hose into the suction inlet push it until it clicks. (fig. 28.)
To disconnect the hose from the suction inlet push the button at the end of the hose.
FILTER INDICATOR LIGHT
Before commencing cleaning, plug the cleaner in and turn it on (without the hose attached
to the cleaner ). If the light is on, clean the filter.
If the light is not on, attach the hose and all the other necessary attachments and com-
mence cleaning.
The light will flicker on and off whilst cleaning. This is normal.
SERVICE
Should you require service on your Boss cleaner, please telephone the Electrolux
Group Floorcare Helpline on 08706 055 055.
PROTECTING THE ENVIRONMENT
Attempt to recycle packaging material and old appliances.
The cardboard packaging can be placed in the waste paper collection.
Deposit the plastic bag made of polyethylene (PE) at the PEcollection point for recycling.
Recycling the appliance at the end of its life:
The plastic components all carry a material identification marking so that, like the other
materials, they can by recycled at the end of the life of the appliance.
Please inquire with your local authority.
All manuals and user guides at all-guides.com
7106, 7116
DESCRIPTION OF PARTS
1. Suction inlet
2. Electronic filter indicator
3. On/off switch
4. Cable rewind button
5. Wheel
6. Dust container
7. Carrying handle
8. Dust container open button
9. Hose
10. Metal tubes (B7106)
IMPORTANT SAFEGUARDS
Please read this instruction booklet carefully.
Before using the appliance, check that the mains power voltage corresponds to the voltage shown on
the rating plate.
Do not switch the appliance on if it appears to be faulty in any way or it has a damaged cord or plug.
Do not try to repair the appliance by yourself. For repairs or accessories, contact the Electrolux
Group Floorcare Helpline on 08706 055 055.
Always remove the plug from the power socket when the appliance is not in use and before carrying
out any cleaning or maintenance operations.
Never leave the appliance unattended when it is switched on. Keep the appliance out of reach of chil-
dren.
This appliance is for domestic use only. Use as described in this instruction booklet.
Do not pull the appliance by the cord. Do not unplug by pulling on the cord.
Do not use the appliance on wet surfaces or to vacuum liquids, mud, ash and burning cigarette butts.
Do not vacuum up any highly flammable or explosive substances or gases.
Do not unplug the vacuum cleaner with wet hands.
Do not operate or store the vacuum cleaner too close to heaters and radiators, stoves etc.
Before you start using the vacuum cleaner, please remove large or sharp objects from the floor in order
to prevent damage to the dust container and hose.
INSTRUCTIONS FOR USE
Before operating the vacuum cleaner, make certain that the filters are in the proper position.
Unwind a sufficient length of cable and insert the plug into the power socket. A YELLOW mark on the
power cable shows the ideal cable length. Do not extend the cable beyond the RED mark.
Press the ON/OFF button to switch the appliance on. On initial start up full power is reached after
approximately 1-2 seconds.
To rewind the power cable, press the rewind button with your foot, and guide the cable with your hand
to ensure that it does not whip causing damage.
Always remove the hose from the vacuum cleaner when in storage.
7106, 7116
11. Telescopic tubes (B7116)
12. Dual purpose floor nozzle
13. Crevice nozzle
14. Upholstery nozzle with plush plate
15. Dusting brush
16. Cartridge filter
17. Caddy
18. Vertical parking
19. Horizontal parking

Advertisement

loading

This manual is also suitable for:

The boss 7116