Advertisement
...you want to
correctly care for
and clean your
dryer:
...you see this
indication and
the red icon
:
Message
displayed
F 02
F 05
F 06
F 14
F 15
fast blinking
AFTER-SALES SERVICE
If the fault is still present once the above checks have been undertaken or should the fault occur for a second time, switch the
machine off. Please contact your After-Sales Service representative (for more information, refer to the warranty manual).
Please have the following details ready when calling your after-sales service representative:
• The nature of the fault.
• The dryer type and model.
• The service code (the number after the word Service on the adhesive
rating plate) on the right-hand side when the door is opened.
6
How to proceed if ...
Clean the filter at the end
of every cycle.
Empty the water container
at the end of each drying
cycle.
Clean the heat exchanger
at least every month.
(For further information
see chapter "Heat
Exchanger" in the
Instructions for Use).
Check needed by customer before Service call
Turn OFF the dryer. Unplug the dryer for more than 3 seconds. Plug the dryer
and start a new cycle with humid laundry. If the problem persists please call
Customer Service.
Turn OFF the dryer. Unplug the dryer for more than 3 seconds. Clean the lint
filter. Check if the ambient temperature is more than 5°C. Plug the dryer. Start
a new cycle with humid laundry. If the problem persists, please call Customer
Service.
Turn OFF the dryer. Unplug the dryer. Empty the bottle. Clean the fluff filter
and the heat exchanger. Plug the dryer. Start a new cycle with humid laundry. If
the problem persists, please call Customer Service.
Turn OFF the dryer. Unplug the dryer. Call the Customer Service.
Turn OFF the dryer. Unplug the dryer. Call the Customer Service.
• Open the door.
• Pull the filter upwards.
• Open the filter.
• Brush lint using a soft brush or your
fingertips.
• Close the filter.
• Push the filter back into place.
• Pull the handle to remove the water
container.
• Empty the water container.
• Replace the water container when
empty by pushing it completely back in
place.
• Remove fibres in and around the water
evacuation hole at least once per month.
Advertisement
