Table of Contents
Advertisement
Electromagnetic Immunity Statement
This equipment has been tested and found to comply with the limits of
EN 50082-2 (Electromagnetic Immunity for heavy industry).
CAUTION NOTICE
1. No user serviceable parts. All installation and servicing to be
2. The rack mounted version of this unit can be mounted anywhere in a
3. The connection of such equipment to a public telecommunications
4. Class 1 LED product.
Environmental Considerations
Equipment in a Rack
1. Elevated Operating Ambient Temperature - If installed in a closed or
2. Reduced Airflow - Installation of the equipment in a rack should be
3. Mechanical Loading - Mounting of the equipment in a rack should
4. Circuit Overloading - Consideration should be given to the
5. Reliable Earthing - Reliable earthing of rack-mounted equipment
All manuals and user guides at all-guides.com
conducted by qualified service personnel.
19 inch rack providing a 1.75 inch air gap is left above and below
and a 1.0 inch air gap is left on the sides.
network in a European Community Member State will be in
violation of the national law implementing Directive 91/263/EEC on
the approximation of the laws of the Member States concerning
telecommunication terminal equipment, including mutual
recognition of their conformity.
multi-unit rack assembly, the operating ambient temperature of the
rack environment may be greater than room ambient. Therefore,
consideration should be given when installing the equipment in a
rack. Maximum ambient temperature of Optica Technologies
Incorporated equipment is +40º C.
such that the amount of airflow required for safe operation of the
equipment is not compromised.
be such that a hazardous condition is not achieved due to uneven
loading.
connection of equipment to the supply circuit and the effect that
overloading of circuits might have on over-current protection and
supply wiring. Appropriate consideration of equipment nameplate
rating should be used when addressing this concern.
should be maintained. Particular attention should be given to supply
connections other than direct connections to the branch circuit (e.g.,
use of power strips).
Advertisement
Table of Contents
