Advertisement
5.7
Attach the rear panel slots and lock support tubes.
5.7.1 Attach the left and right rear panel slots to the side panels
using four sets of M6x16mm screws and M6 nylon lock nuts.
5.7.2 Attach the left and right lock support tubes to the other end of
the side panels using four sets of M6x35mm screws and M6
nylon lock nuts.
fig.8
5.8
Attach the side panels and front panel.
5.8.1 Attach the left and right side panel assemblies to the bottom
panel using the four hinge pins as shown in fig.8.
5.8.2 Attach the front panel to the bottom panel using two hinge pins
as shown in fig.9.
fig.9
5.8.3 Lock each side panel to the front panel as follows. Rotate the
handles at each top corner of the front panel (see fig.9)
through 180° so that they are pointing upwards. Let the bent
part of each handle protrude into the slotted tag on each side
panel. Rotate the handles back down into their original
positions so that the slotted tags are retained against the side
edges of the front panel.
fig.10
fig.7
5.9
Attach the rear panel.
5.9.1 Slide the rear panel down into the slotted channels at the rear
of each side panel. At the bottom edge of the rear panel are
two pins which must pass through holes in the base panel. At
the top corners of the rear panel are two more pins that must
pass into small tubes in the corners of the side panels in order
to lock the panels together. See fig.10.
fig.11
fig.12
Original Language Version
TBB230
Issue no.1
17/11/11
Advertisement
