FAVI RioHD-LED-2 Instructions Manual

Universal ount for led-2 projector

Hide thumbs Also See for RioHD-LED-2:

Table of Contents

Download this manual See also: User Manual

FAVI universal mount instructions, LED-2 projector.

Before you begin, please make sure you have the following tools on hand:

● Socket driver with an 8mm socket

● 7mm wrench and socket

An Allen wrench is also required. Your mount comes supplied with this already.

Step 1: Loosen the four 8mm bolts located in the middle of the leg assembly. Then use

the Allen wrench to loosen the leg bolts. Do not remove any of the bolts yet.

Step 2: Remove the 8 MM bolt for the top right leg, then remove the leg:

Table of Contents

Need help?

Do you have a question about the RioHD-LED-2 and is the answer not in the manual?

Page 1 FAVI universal mount instructions, LED-2 projector. Before you begin, please make sure you have the following tools on hand: ● Socket driver with an 8mm socket ● 7mm wrench and socket An Allen wrench is also required. Your mount comes supplied with this already.
Page 2 Replace the longer inner leg with the shorter inner leg. Tighten the bolt just enough to allow the piece to slide freely inside the outer leg. Step 4: On the LED-2 projector, remove the four pads on the projector’s feet:...
Page 3 If need be you can use a small pair of needle nose pliers to remove these foot pads. Step 5: Attach the leg assembly to the projector. Use the 7mm bolts to attach the mount’s legs to the projector. For now, only attach the bolts loosely.
Page 4 Step 6: Use the last 7mm bolt to loosely attach the final leg to the projector. You can then rotate the leg and slide it into the leg assembly. Replace the 8mm bolt you removed in Step 2. Do not tighten it yet.
Page 5 Step 9: Reinsert the two screws that you removed in the previous step and tighten them. After the projector is mounted, you can loosen these two screws to change the angle of the projector. Step 10: Locate the height adjuster. It consists of two rectangular tubes, one inside the other.
Page 6 The projector mount can now be attached to the ceiling. After securing the mount to the ceiling, you can adjust the height and angle of the projector.