Table of Contents
Advertisement
Further problem solving:
Safety Reset
1. These dryers have a safety cut out switch which is activated by temperature.
2 . T he safety reset button is on the backboard. If your dryer not heating this button must be reset before
the dryer will operate again. You may need to wait 10 minutes for cooling to occur.
3 . T he most common reason for the dryer to overheat is a blocked filter. Clean the lint filter after each load
to prevent overheating of the dryer.
I t will only be necessary to press the safety reset button if the dryer not heating. Allow the dryer at least
10 minutes to cool down before pressing the button .Press the white button in until you feel the reset
click. Cleaning the filter after each load will avoid repetitive operation of the safety cut out switch.
The cut out switch may operate for the following reason:
1. Lint filter is blocked.
2. Exhaust outlets blocked at the back of the dryer.
3. Poor ventilation in the laundry or room-open a window or door
4. Lightweight garment eg. Handkerchief, sucked over the filter.
Safety Reset Button:
Use your finger or a pencil to press the button in until you feel it click.
User Manual
14
15
Purchase Details
For future reference, please record the following
information which can be found on the rating plate and the
date of purchase which can be found on your sales invoice.
STORE DETAILS
STORE NAME
|
ADDRESS
|
TELEPHONE
|
PRODUCT DETAILS
MODEL NO.
|
SERIAL NO.*
|
Attach your receipt
to this page
inalto.com.au
The rating plate of your hob is located on the underneath
of the appliance. Therefore please fit the duplicate data
plates or label on the outside of the cupboard to sure that
the label can be easily seen during operation.
PURCHASE DATE
|
Advertisement
Table of Contents
