Extreme Networks Virtual Chassis Installation Manual page 20

I S V
NSTALLING THE UMMIT IRTUAL
I
NSTALLING THE
To install the Summit Virtual Chassis, follow these steps:
1 Mount the Summit Virtual Chassis in the equipment rack, or, if it will be located on
a table, place the rubber feet on the bottom of the Summit Virtual Chassis.
For more information on installing the mounting brackets, refer to the Summit
Switch Installation and User Guide .
2 If you are using the RPS ports on the Summit Virtual Chassis to connect one or two
Summit switches, do the following:
a Using the supplied cables, connect the RPS port on the Summit Virtual Chassis to
the RPS port on each Summit switch.
The RPS DC cable must be connected to the Summit switch prior to connecting
the AC power cord to the Summit Virtual Chassis.
b Tighten the screws connecting both sides of the RPS cable.
Ensure that the cable is secured and is making good contact prior to turning on
the Summit Virtual Chassis.
c Connect an AC power cord to each power socket.
d Plug the power cords into properly grounded AC outlets.
When disconnecting the Summit Virtual chassis, the AC power cords must be
removed from the Summit Virtual Chassis before removing the RPS DC cables.
3 Connect the fiber-optic cable between each Summit switch port and each Summit
Virtual Chassis port.
If you are cabling a single Summit switch to two Summit Virtual Chassis in a
parallel configuration, ensure that you cable each switch port to the same port
number on the two different Summit Virtual Chassis.
18
C
HASSIS
S V
UMMIT IRTUAL
C
HASSIS
S V C
UMMIT IRTUAL HASSIS
D I G
ESIGN AND NSTALLATION UIDE