Folding & Unfolding Your Scooter (Battery Removed); Adjusting Your Tiller; Removing Your Battery Pack; Removing Your Seat - TGA MINIMO AUTOFOLD Operating Instructions And Owner's Handbook

WARNING!
• Always take care when folding and
unfolding your scooter that your hands
and fingers are clear of moving parts.
• The automatic folding process may
stop if an obstruction is preventing it
to fold
fully.
Folding & unfolding your
scooter (with the battery
removed)
You can fold and unfold your scooter with
the battery removed. This enables you to
charge your battery remotely from the
scooter or remove the battery in order
to travel on a plane. To fold and unfold
your Minimo Autofold with the battery
removed:
1. Remove the battery as explained on page

6, 'Removing your Battery Pack'

2. Connect the remote battery connection
lead that was supplied with your scooter
to the charging socket on the top of the
battery, and to the charging socket on the
side of your scooter, ensuring that they are
firmly located.
3. Carry out the same folding and unfolding
procedure, detailed previously as if the
battery was located on the scooter.
4. After folding or unfolding your scooter
with the battery removed, you must remove
the remote battery connection lead and
store it safely. Refit the battery in order to
drive your scooter.
WARNING!
Never drive your scooter with the
battery removed and connected to the
side charging socket.

Adjusting your tiller

If you'd like to adjust
the height of your
tiller, simply turn the
adjustment wheel anti-
clockwise until the top
part of the tiller moves
freely up and down.
Then just move the
top half of the tiller to
the height you would
like and tighten the
adjustment wheel by
turning it clockwise
until tight.
Removing your battery pack
To remove the battery
pack, first ensure the
pack is unlocked by
inserting the key into
the pack and turning
it 90° anti-clockwise
to the unlock position.
Then simply lift the
pack up using the
handle provided.

Removing your seat

To remove your seat,
follow these two
simple steps:
1. Pull and rotate
the red circular knob
located under the
seat so that it is
locked open.
2. Slide the seat
forwards slightly and lift
away from the base.
To replace the seat reverse these steps.
WARNING!
Always ensure the seat is locked in
place before attempting to get on.
Failure to check this could result in
injury.
7