Your Scooter Controls - TGA MINIMO AUTOFOLD Operating Instructions And Owner's Handbook

Your scooter controls

A. Horn – Press the button to sound your horn.
B. Key Fob – Press the power button on the
Minimo display panel until the light surrounding
the button illuminates red, then swipe the
key fob over this button to put the scooter
into 'driving mode' (indicated by the light
changing to blue). Always keep the fob with you
when driving.
C. Battery Condition Indicator – When
your scooter is switched on, the lights on the
indicator will show the level of battery life. As
the battery is used, the lights will individually
extinguish from green to red – all lights on
meaning fully charged, only red lights showing
meaning your battery needs to be recharged.
For more information see the 'Charging Your
Scooter' section.
D. Power Button – Press the power button to
wake up the system. When it shows red, it is
awaiting the command from the fob to go into
'drive mode' – which will turn this to blue. Press
again to switch the scooter off. (In the diagram
below, the power button is shown as a blue
circle, as it is hidden by the Key Fob).
I A
B
E. Speed Adjuster – This allows you to pre-select
your desired maximum speed. Turn the adjuster
knob fully anti-clockwise for the lowest speed
and gradually rotate clockwise to increase your
maximum speed.
F. Throttle Control Levers – The throttle control
also adjusts the speed of your scooter. The further
you move the control lever the faster you will go.
To move forwards, pull the red right-hand lever
towards the handlebar. You can either pull the red
right hand lever or push the black left-hand lever).
To reverse, pull the black left-hand lever towards
the handlebar.
G. Hazard Light Button (located on the end
of the handlebar) – Press, release and wait five
seconds. The front light and rear lights will flash.
H. Light Switch – The switch under the control
panel will operate the front and rear lights. Please
note the front day-running light will always remain
on while your scooter is in use. This switch will put
the front light on 'full beam'.
I. Autofold Button (located on the end of the
handlebar) – When the scooter is turned off, press
the button and press on the foot pedal to start the
automatic folding process.
F
C
D
H
4
E
G