Table of Contents
Advertisement
Safety Information (continued)
AIR COMPRESSOR AND AIR TOOL SAFETY
1. Risk of Bursting. Do not adjust the regulator to result in output
pressure greater than the marked maximum pressure of this air
tool.
2. Ensure the hose is free of obstructions or snags. Entangled or
snarled hoses can cause loss of balance or footing and may
become damaged.
3. Never leave a tool unattended with the air hose attached.
4. Do not operate this tool if it does not contain a legible warning
label.
5. Do not continue to use a tool or hose that leaks air or does not
function properly.
6. Never direct a jet of compressed air toward people or animals.
7. Protect your lungs. Wear a face or dust mask if the operation is
dusty.
Important Warnings - Sanders
1. Eye protection, safety gloves and safety aprons must always we worn when operating a sander or
polisher.
2. Never adjust the sander or polisher or change the backing pad, sanding disc, sanding belt or
polishing bonnet unless the air supply and air hose is disconnected from the tool
3. Only use backing pads and polishing backing pads that have a rated speed then same as the sander
or polisher or higher.
4. Never attempt to modify or adapt a sander or polisher for use with a grinding wheel or cut-off wheel
or wire brush.
5. Only personnel trained in the correct methods to change pads, sanding discs, sanding belts and
polishing bonnets should conduct these operations.
Specifications
Motor
Motor
Model
(HP)
(kW)
UT8727T-20
0.40
0.29
Pad Size
Speed
Spindle/Collet
Dia. (in.)
(RPM)
Exhaust
Size (in.)
2"
18,000
Rear/Front
1/4"
WARNING: Some dust created by power sanding, sawing,
grinding, drilling and other construction activities contains
chemicals known to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
Lead from lead based paint, crystalline silica from bricks
and cement and other masonry products, arsenic and
chromium from chemically-treated lumber.
Your risk from those exposures varies, depending on how
often you do this type of work. To reduce your exposure to
these chemicals: work in a well-ventilated area, and work
with approved safety equipment, such as dust masks that
are specifically designed to filter out microscopic particles.
Vibration Level (m/sec2): 4.53
Weight
Weight
Length
Length
(lb.)
(Kg)
(in.)
(mm)
1.5
0.68
6.5
157.5
Please contact 1-800-356-3392 for further assistance.
Noise Level (dBA): 83.2
Rec.
Air Inlet
Rec. Hose Air Cons Av. Air Cons
Pressure
(NPT)
(I.D. in.)
(cfm)
90 psi-6.2 bar
1/4"
3/8"
18
FLORIDA-PNEUMATIC.COM
(cfm)
3.5
Advertisement
Table of Contents
