Advertisement
3.6
SETTING MAxIMUM TORQUE VALUE
Pre-setting Torque Value
Increase Max. Torque Value
Decrease Max. Torque Value
Note: If the display shows
of more than 110% of the maximum specification applied.
3.7
PEAK HOLD / TRACK MODE SELECTION
Long Press
Set Peak/Track mode
Press
Set Peak/Track mode
Press
Communication
Press
Peak Hold Mode
Note: Communication is for calibration of torque wrench. Please
contact your Sealey dealer for more information.
Press
Press
the wrench has had a torque
for Selection
*Note 1
Communication
(Exit)
3.8
TRACK MODE OPERATION
START
(System initial)
*Note 1
Max. Target Value
Apply Torque
Current Torque Value
Over 90% of Max. Target Value
Current Torque Value
((...((...
...))...)) ((...((...
n n n
Buzzer
Over Max. Target Value
((((((((
))))))))
n n n
Buzzer
Note:
1.
If the display shows
of more than 110% of the maximum specification applied.
2.
The green LED will be on for 90% of maximum setting
torque.
3.
The red LED will be on 100% of maximum setting torque.
...)) ...))
Green LED
Over 90% of Set Torque
*Note 2
((((((((
))))))))
Red LED
Over Max. Set Torque
*Note 3
the wrench has had a torque
STW298
Issue No: 1 - 02/06/09
Advertisement
