Table of Contents
Advertisement
30/60
Installation
Bosch Rexroth AG, A10VGT Series 11, RE 92770-01-B/11.2016
7.4 Installing the axial piston unit
7.4.1 Preparation
1.
Check the specifications on the name plate of the axial piston unit to see if the
axial piston unit is correct.
2.
Compare the material number and designation (type code) with the details in the
order confirmation.
If the material number for the axial piston unit does not correspond to the one
in the order confirmation, contact Bosch Rexroth Service for clarification, see
Chapter 10.5 "Spare parts" on page 48.
3.
Before installing, completely empty the axial piston unit to prevent mixing with
the hydraulic fluid used in the machine/system.
4.
Check the permissible direction of rotation of the axial piston unit (on the name
plate) and make sure that this corresponds to the direction of rotation of the
drive motor.
L
R
Fig. 10: Direction of rotation
l
Counter-clockwise
R
Clockwise
The direction of rotation as specified on the name plate determines the direction
of rotation of the axial piston unit as viewed on the drive shaft, see Chapter 5.3
"Product identification" on page 21. For information on the direction of
rotation of the drive motor, please refer to the drive motor manufacturer's
operating instructions.
7.4.2 Dimensions
The installation drawing contains the dimensions for all connections and ports on
the axial piston unit. Also observe the manuals provided by the manufacturers of the
other hydraulic components when selecting the required tools.
Advertisement
Table of Contents
