Network Settings; Manual Network Settings - Sanyo FW55C87F Owner's Manual

Network settings

1
Press Z and use J K to select Setup then press OK.
2
Use H I J K to select Network settings, then press OK.
3
Adjust the following items.

Manual network settings

1
Use H I to select Manual network settings, then press OK.
Manual network settings Network selection
Connection test Wireless network setting
Setting status IP configuration
Home network Proxy configuration
Wake-on-LAN(DIAL)
Apps
Samba interactive TV settings
Reset network settings
Network selection
2
Use H I to select Network selection, then press OK.
3
Use H I to select the desired setting, then press OK.
If you connect to an Ethernet cable, select Wired
Wired
to connect to the internet.
If you have a router with easy connect function,
Wireless
select Wireless to connect to the internet.
Wireless network setting
This menu is displayed only when you set Wireless in Network
selection. In order to use a wireless network, you must set up a
connection to the AP (e.g. wireless router).
2
Use H I to select Wireless network setting, then press OK.
Auto
Search for wireless networks automatically and select the SSID from the
list.
3
Use H I to select Auto, then press OK.
4
The list of wireless networks will be displayed. Use H I to select
the appropriate the SSID, then press OK.
Auto Router 1
Manually enter your SSID Router 2
Router 3
Router 4
If you select the SSID with
●
will appear. Enter the WEP
network using H I J K, then press OK.
If you select the SSID has an easy connect, the easy connect
●
setting screen will appear. Use H I J K to select a setting, then
press OK.
Select this setting if your router has an easy
connect button. Start scanning for wireless
networks on the TV after pressing the easy
Simple Connect
connect button on your router. If connection test
fails, try Simple Connect again.
refer to the router's manual for more details.
Select this setting if your router has an easy
connect feature but does not have an easy
Pin code connect button. Enter the 8-digit PIN code shown
on your TV in the Router settings menu via PC
before Connect is selected.
If your wireless network with authentication
setting (WEP
screen will appear. Enter the WEP
Manual
of the selected wireless network using H I J K,
then press OK.
Simple Connect cannot be used when the security protocol is set
*1
to WEP. Change the Access Point's security mode from WEP to
others (recommended).
WEP is not recommended to be used due to its major security
*2
flaws. Change the security protocol on the wireless router to others
(recommended) mode.
Confirmation message will appear. Select OK to complete the settings.
Note(s)
For a wireless network with authentication setting, key icon appears to the right hand of the
●
SSID.
Signal icon shows the strength of the signal.
●
WEP / others key appears as asterisks on the confirmation screen.
● *2
The wireless LAN supports following specifications.
●
Wireless standards: IEEE 802.11 a/b/g/n/ac
–
Frequency spectrum: 2.4GHz / 5GHz
–
Security protocol: WEP / others
*2
–
40
Simple Connect
Pin code
Manual
, WEP / others Key entry screen
*2
/ others key of the selected wireless
*2
If it fails then
*1
, others), WEP / others Key entry
*2 *2
/ others key
*2
Continued on next page.
.
English