Porter-Cable 552 Instruction Manual page 12

904376 - 12-31-01.qxd
INSTALL POCKET
CUTTING MOTOR
C A U T I O N :
Disconnect pocket
cutting motor and
machine from power
source and place
switches in the OFF
position.
1. Loosen
clamp nut (A) Fig. 12:
use the 7 " wrench to
/
16
rotate clamp
c o u n t e r c l o c k w i s e
several turns to loosen clamp.
2. Orient motor as shown in Fig. 13, and insert into clamp. Seat motor into
mounting bracket: the upper motor housing (A) Fig. 14, must touch the
mounting bracket (B) Fig. 14.
3. Tighten the motor clamp nut firmly.
4. Insert motor power cord into receptacle (see Fig. 15).
CAUTION: Make sure machine power cord is not connected to
power source.
5. Set motor switch (A) Fig. 15, to the ON position.
A
2/11/02 2:43 PM Page 12
motor
nut
A
Fig. 12
B
Fig. 14
12
A
Fig. 11
Fig. 13
Fig. 15
A