Quick Installation; Additional Software Installation (Optional) - ViewSonic TD2430 User Manual

Quick Installation

1. Connect video cable
• Make sure both the display and computer are turned OFF.
• Remove rear panel covers if necessary.
• Connect the video cable from the display to the computer.
Macintosh users: Models older than G3 require a Macintosh adapter. Attach the
adapter to the computer and plug the video cable into the adapter.
2. Connect power cord (and AC/DC adapter if required)
DisplayPort
Audio In
USB UP
USB Down
3. Turn ON the display and computer
Turn ON the display, then turn ON the computer. This sequence (display before
computer) is important.
NOTE: Windows users may receive a message asking them to install the INF file.
To download the file, visit the "Download" section of the monitor product page on
the ViewSonic website.
4. Windows users: Set the timing mode (example: 1024 x 768)
For instructions on changing the resolution and refresh rate, see the graphics
card's user guide.
5. Installation is complete. Enjoy your new ViewSonic display.
HDMI
VGA
4
Audio out
Power Cord