Information On The Display - Siemens WT47W540BY Installation And Operation Instruction Manual

Information on the display

en
Y
Information on the display
I n f o r m a t i o n o n t h e d i s p l a y
Faults
ð on the display and
drying has stopped.
ñ on the display.
é on the display.
The display goes out and
Start/Pause Ü flashes.
* Depending on how the appliance is equipped or the available accessory
--------
If you cannot rectify the fault yourself by turning the appliance off and then on
Note:
again, please contact our after-sales service.~ Page 45
38
Cause/remedy
Empty the condensation container and reinsert it.~ Page 29
■
Press Start/Pause Ü.
Once you have installed the optional drain hose*, make sure that it:
■
Is correctly connected ~ Page 32
Is free of kinks
Is not blocked or clogged, e.g. with deposits
Remove the fluff.~ Page 30
Press Start/Pause Ü.
Not a fault. The heat exchanger is being cleaned automatically. Do not pull out
the condensation container while this is displayed.
Not a fault. Energy saving mode is active .