Energy-Saving Tips - Siemens WT47W540BY Installation And Operation Instruction Manual

:
Warning
Risk of injury/material
damage/damage to the
appliance!
The use of spare parts and
accessories supplied by other
brands is dangerous and may
result in injury, material damage
or damage to the appliance.
For safety reasons, use
genuine spare parts and
accessories only.
Caution!
Material damage/damage to
the appliance
Cleaning agents and agents for
pretreating laundry (e.g. stain
removers, prewash sprays, etc.)
may cause damage if they
come into contact with the
surfaces of the appliance.
Therefore please note:
Do not allow these agents to
■
come into contact with the
surfaces of the appliance.
Clean the appliance with
■
nothing but water and a soft,
damp cloth.
Remove any detergent,
■
spray or other residues
immediately.

Energy-saving tips

7
Energy-saving tips
Spin the laundry before drying. The
■
E n e r g y - s a v i n g t i p s
drier the laundry, the shorter the
programme will be, in turn reducing
energy consumption.
Load the appliance with the
■
maximum loads permitted for the
programmes.
If the maximum load is
Note:
exceeded, this extends the programme
duration and increases energy
consumption.
Operate the appliance in a ventilated
■
room and make sure that the air inlet
on the appliance is unobstructed so
that air exchange can take place
unhindered.
Regularly remove the fluff from the
■
appliance. If there is fluff in the
appliance, this extends the
programme duration and increases
energy consumption.
If you do not perform any actions on
■
the appliance for an extended period
before the programme starts or once
the programme has ended, the
appliance will automatically switch to
Energy saving mode. The display
and indicator lights will go out after a
few minutes and Start/Pause Ü will
flash.To end Energy saving mode, all
you need to do is perform an action
on the appliance, such as opening
and closing the door.
If you do not perform any actions on
■
the appliance for an extended period
when it is in Energy saving mode,
the appliance will automatically
switch itself off.
en
11