Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Burco RG60NG
Summary of Contents for Burco RG60NG
- Page 1 User Instruction Manual T I T A N Commercial Catering Range These instructions cover the Burco Titan 4 Burner Commercial Catering Range RG60NG, SKU 444440349 RG60NG, SKU 444440349 Glen Dimplex Professional Appliances Stoney Lane, Prescot, Merseyside, L35 2XW Tel: 0844 815 3755...
- Page 2 INTRODUCTION This appliance must be installed by a competent person in compliance with the installation and servicing instructions and national regulations in force at the time. Particular attention must be paid to the following: Gas Safety (Installation & Use) Regulations. Health and Safety at Work etc Act.
- Page 3 These appliances must be installed and serviced by a competent person as stipulated by the Gas Safety (Installation & Use) Regulations. IMPORTANT The installer must ensure that the installation of the appliance is in conformity with these instructions and National Regulations in force at the time of installation. Particular attention MUST be paid to: •...
-
Page 4: Gas Supply
INSTALLATION AND SERVICE GUIDE IT IS MOST IMPORTANT THAT THESE INSTRUCTIONS BE CONSULTED BEFORE INSTALLING AND COMMISSIONING THIS APPLIANCE. FAILURE TO COMPLY WITH THE SPECIFIED PROCEDURES MAY RESULT IN DAMAGE OR THE NEED FOR A SERVICE CALL. PREVENTATIVE MAINTENANCE CONTRACT In order to obtain maximum performance from this unit we would recommend that a Maintenance Contract be arranged. -
Page 5: Burner Adjustment
1.3 HEAT INPUTS Heat Input Heat Input, (kW net) Low Setting (kW net) Country Gas Hotplate Oven Total Hotplate Oven GB/IE Natural gas (G20) 6.1 kW 6.0 kW 30.4 kW 1.0 kW 1.0 kW 1.4 INJECTOR & BYPASS STAMPINGS Injector Stamping Bypass Screw Stamping Country Gas Hotplate... -
Page 6: Instruction To User
for gas tightness. 2.3.2 Checking the performance of the controls 1. Light hotplate or oven as detailed in Section 2.3.3. Check ignition is smooth and without delay. Repeat operation several times. 2. Place a thermometer in centre of oven and select 210°C on thermostat knob. Allow oven to heat up and check temperature is 210 +/- 15°C. - Page 7 upwards to an angle of approximately 45° and then pull the hotplate forward. 3. The hotplate should now be free from the rear vent and can be removed from the appliance. 3.1.3 Replacement of hotplate burner (jet holder) 1. Remove hotplate as detailed on the previous page. 2.
-
Page 8: Oven Thermostat
3. Open oven doors, remove shelves and oven base panel. 4. Remove nut securing thermocouple sensor to burner bracket. 5. Remove thermocouple from bracket. Pull remainder of thermocouple into oven, through hole in left hand oven side panel. 6. Replace in reverse order and take care not to overtighten the connection at the thermostat rear. - Page 9 7. If a flame is still not present then re-check from start. If a flame is established but not maintained then follow this check list: 1. Check thermocouple sensor is secured correctly and that burner ports are clean. 2. Check that thermocouple is not damaged and is securely fixed to FFD section of gas control.
-
Page 10: Section 1 - About Your Appliance
USER’S GUIDE SECTION 1 - ABOUT YOUR APPLIANCE All models are fitted with flame failure devices to shut off gas supply to burners if flames are extinguished. The oven is thermostatically controlled. All taps are the safety type with fixed HIGH and LOW settings. Hotplate controls Control knob markings are as indicated below. -
Page 11: Section 3 - Cooking Hints
IMPORTANT INFORMATION PLEASE READ THE FOLLOWING VERY CAREFULLY..AVOID MIS-USE! (MIS-USE OF THIS PRODUCT CAN BE HARMFUL). Guidance Rules for the SAFE USE of a gastronome pan on the hotplate, Size 2/1 or 1/1 gastronome pans. • Whenever two or more hotplate burners are operated below a gastronome pan, the heat input of each burner should be reduced. -
Page 12: Section 4 - Cleaning And Maintenance
beyond the rear shelf upstand. Preheat time Allow at least 15 minutes from lighting a cold oven before a full load of food may be cooked. Put food in quickly and close the doors firmly. SECTION 4 - CLEANING AND MAINTENANCE All surfaces are easier to clean if spillages are removed before they become burnt on and if units are cleaned daily. - Page 13 6. Light burner to check that it operates correctly. Note: Ensure that all parts are dried thoroughly prior to relighting. Note: This process should be followed prior to calling for a Service Engineer. Failure due to lack of proper cleanings may result in work being charged for. Oven Clean while oven is warm but not hot.
- Page 14 GUARANTEE This appliance is guaranteed against defective materials or faulty workmanship, for a period of 12 months on labour and 36 months on parts. This guarantee is given subject to the appliance being used in accordance with the instructions supplied, and on the supply voltage marked on the rating label. The guarantee is subject to fair wear and tear conditions.
-
Page 15: Spares List
SPARES LIST Part Number Description 502989600 Bracket electrode support 083061800 Burner assembly 082982600 Burner cap assembly 082982500 Burner skirt 533060900 Oven door outer 503060700 Door oven inner panel 082510900 Electrode oven 503061300 Facia panel 081502200 Generator ignition piezo black 080482809 Ignition lead 082983500 Handle door... -
Page 16: Customer Helpline
Customer helpline For spares and after-sales service please contact Burco on: T: 0844 815 3755 F: 0844 815 3748 info@gdha.com Glen Dimplex Professional Appliances (A Division of Glen Dimplex Home Appliances) Stoney Lane, Prescot, Merseyside L35 2XW www.burco.co.uk 082758100 © 03.2011...
Need help?
Do you have a question about the RG60NG and is the answer not in the manual?
Questions and answers