Advertisement
3.1
Main body section
3.1.1 Remove the top cover (See figure 1)
(1) Remove the four screws A attaching the top cover on both
sides of the main body.
(2) Remove the five screws B attaching the top cover on the
back of the main body.
(3) Raise the both sides and lower part of the rear of the top
cover, with opening them slightly in an outward direction.
And the top cover will be removed.
3.1.2 Remove the front panel assembly (See figure 2, figure 3)
• Prior to performing the following procedure, remove the top
cover.
• There is no need to remove the mechanism assembly.
(1) Disconnect the card wire from connector
main board.
(2) Disconnect the card wire from connector
FL display board.
(3) Hook a and b are removed respectively, and the front panel
assembly is removed.
1-6 (No.XA013)
SECTION 3
DISASSEMBLY
A
x
CN3002
on the
CN3002
CN7001
on the
Front panel
assembly
Top cover
Top cover
2
A
x
2
Fig.1
Front panel assembly
Main board
Fig.2
Hook a
Hook b
Hook b
Hook b
Hook a
Fig.3
B
B
B
B
B
FL Display board
CN7001
Advertisement
