Operation Area not be used for commercial or industrial applications. enclosed area, such as a closet. temperature will not below 5°C or above 32°C. Allow at least 30-45cm of air space on all sides of the unit. ffect. Correct Below Above Do not point the air outlet at the wall Note:...
Check Before Operation aced. Below are the checking steps: 1. Hold the handles on both sides of the water bucket and pull it out following the arrow direction. moved a little after long-time transportation. If it's not placed properly, move it to the correct position by hand.
Operation Method sleeping Bucket full light space indicates bucket lock on high, mid living space mode on needs to be emptied power on indicator and low fan mode on indicator or it is not in the indicator indicator light light indicator light indicator light light...
Page 8
lock buttons. If this function is turned on, Button Locked Indicator will be on and display window shows LC, which will blink for 3 times. Then ambi- ent humidity is displayed again. To turn off this function, hold + and - button simultaneously for 3s and the indicator will be off.
Continuous button Press this button to set continuous dehumidify. Note: When selecting CO mode, drain hose has to be installed. Otherwise, unit will stop when water bucket is full. FILTER Button been operating for 250 hours, Filter Cleaning Indicator will be lit up to remind Other Instructions 1.
Page 11
Option 2 Gravity Drain Hose 1. Hose is not provided, so user shall prepare it in advance. [Size: The hose thread should have an outer diameter of 11/16 inches (1.0625 inches or 27.0mm), and a pitch of 11.5 TPI.] 2. Remove bucket from the unit as instructed. 3.
Clean and Maintenance Warning: may lead to electric shock. Otherwise it will damage unit's appearance. 1. Grille and Case To clean the case: When there is dust on the case, use soft towel to dust it off; When the case is very dirty(greasy), use mild detergent to clean it.
(3) After cleaning, replace the drain lid and handle properly. The side with foam plastic should be Foam beneath the drain lid. Do not remove the foam Plastic Float 3. Air Filter when it has been operating for 250 hours. If it is used in dusty places, clean the air filter more often.
Troubleshooting Problem Possible Causes Problem Possible Causes Solution...
Page 15
Problem Possible Causes Solution Power indicator is not lit when power inserted. is connected. loosen. placed. Empt the b c et and replace B c et has been removed. closed. low.
Need help?
Do you have a question about the Giatsu P06 and is the answer not in the manual?
Questions and answers