Advertisement
touchscreen
OFF: Operating system will not receive touch events from the Skin.
STAND-BY: Operating system will temporarily not receive touch events from the Skin.
This way, if you want to adjust some setting you will be able to do it. When you close
'DISPLAX Connect' the touch injection will be automatically re-enabled and the STAND-
BY status will change to ON. This stand-by status is only active when 'DISPLAX Connect'
is open.
G. Configuration wizard: automatically configures the touch parameters i.e. Gain,
Threshold, Shield level. If the configuration wizard fails the touch parameters must be
configured manually. Configuration Wizard is not available for Skin Dualtouch.
Settings
H. Settings tab: touch configuration settings.
H1. Gain: adjusts the signal strength injected by the Touch Controller on the Touch
Sensor - thicker glasses and bigger Touch Sensors may require a stronger signal (higher
GAIN values). Gain values range between 0 and 7.
H2. Threshold: adjusts the threshold level of what is considered a touch. Values vary
between 0 and 50 starting on firmware version 1.5.0. (0 to 15 on firmware version equal
or previous to 1.4.0).
H3. Shield: electromagnetic shielding reduces noise that may exist between the
Skin product and the LCD. Shielding level ranges between 1 and 6, with 6 being the
strongest shielding level. The shielding level should be maintained as low as possible.
H4. Palm: allows the rejection of areas with dimensions larger than a finger, such as a
hand or an arm. (Feature not available in Skin Dualtouch).
H5. Sensor tools: Allows enabling and disabling horizontal and vertical electrodes and
the selection of areas to be activated or deactivated within the touch sensor active
area.
H5.1. Trash: reactivates the electrodes or electrode portions that we have deactivated.
H5.2. Rectangle selection: Enables drawing rectangular areas to be deactivated.
For more exciting multitouch products visit
www.promultis.info
8
or call +44 (0) 239 251 2794
MULTITOUCH SOLUTIONS
Advertisement
