Setup; Power States - Escient FireBall FP-1 User Manual

Fireball media management system
Hide thumbs Also See for FireBall FP-1:
Table of Contents

Advertisement

SetUP

This manual assumes that you followed the printed "Quick Setup Guide" that came with your FireBall. If you have not properly connected your
FireBall to your audio/video system, please go back and follow the "Quick Setup Guide" guide before continuing with this User Manual.

PoWER stAtEs

After the FireBall unit is plugged in, the Standby LED located next to the power button will flash red until the startup process is complete.
Please wait. This may take several minutes.
When the Standby LED is solid RED, the FireBall is now in a standby
or "sleep" mode. There is no video output when FireBall is in standby
mode. Press the Power button (on the front panel or on the remote) once
and the video output is displayed on your TV. The unit is now ON and
the LED will be solid GREEN.
To change from the ON mode to the USB pass-through mode (enabling
you to sync your iPod with your computer if it is connected via an optional
USB cable) press the Power button on the front panel or on the remote
once. The iPod content will be removed from the on-screen Music Guide, and the LED will be solid amber.
Note that the USB mode is only available if you have an iPod docked in the FP-1.
To change from the USB Pass-Through mode back to the standby or "sleep" mode, press the Power button on the front panel or on the remote once.
The video output will go blank and the LED will be solid red.
If power is removed from FireBall for any reason, including a power outage or if the unit is unplugged, FireBall will automatically return to the
Standby state as soon as power is restored. When FireBall is turned on again, FireBall will return to the same source mode that it was in when power
was lost.
To force the FireBall to restart, PRESS and HOLD the Power button on the front of the unit for 4 seconds, and release it when the standby LED starts
blinking.
When the Standby LED is RED and FireBall has completed its startup process, press the Power button once to turn on the FireBall.
PAGE 12

Advertisement

Table of Contents
loading

Table of Contents