How To Clear A Program From Memory (0=Clr); How To Autoprogram The Control Panel (1=Auto) - Ansul AUTOPULSE IQ-301 Installation, Operation And Maintenance Manual

How to Enter Program Change
Program Change
Password
!
Program Change
Password
IQ-301 PN 50036:F 10/29/2001
3.4.2 How to Clear a Program from Memory (0=
The Clear option erases all programming information from the CPU memory of the
control panel. You typically use the Clear function to erase data from the control before
autoprogramming the control panel for the first time or if you remove one or more
devices from the system. For more information on removing devices, refer to "How to
Remove a Device from the Program" on page 76.
1. From the Program Change screen (Figure 53), press the 0 key. The Clear Program
screen displays a verification prompt as shown in Figure 55:
Figure 55 Clear Program Screen
CAUTION: Pressing the
ENTER
programming data from CPU memory.
2. To erase existing programming data, press the
Program Change screen without erasing data, press the
3.4.3 How to Autoprogram the Control Panel (1=
Purpose
The Autoprogram option directs the control panel to identify all detectors and modules
connected to the SLC. You can use the Autoprogram option to create a new program
and add or delete addressable detectors and modules connected to the SLC. Table 16
contains a summary of the Autoprogram functions, when to use the functions, and
where to find information on using the functions.
Autoprogram
Control Panel Configuration
Function
Create a new program A new control panel or a control
for the control panel panel with no existing program
in memory.
Add one or more A program exists in memory and
SLC-connected you want to add a detector or
detectors and modules module to the existing
to an existing program program—without modifying
information for existing
detectors and modules.
Remove one or more A program exists in memory and
SLC-connected you want to remove an installed
detectors and modules detector or module from the
from an existing existing program—without
program modifying information for
existing detectors and modules.
View system defaults A program exists in memory and
you want to view system
settings assigned during
autoprogram, such as custom
labels, passwords, and so on.
Table 16 Autoprogram Functions
PRESS ENTER TO
CLEAR ENTIRE PROGRAM
OR
BACKSPACE TO ESCAPE
key causes the system to erase all existing
ENTER
Refer to
"Create a New Program for the
Control Panel" on page 74
"How to Add a Device to the
Program" on page 75
"How to Remove a Device from
the Program" on page 76
"How to Change Autoprogram
System Defaults" on page 77
Programming
)
CLR
key. To exit and return to the
key.
BACKSPACE
)
AUTO
73