Kenwood NEXEDGE NX-230EX Instruction Manual page 34

ACTIVITY DETECTION
Press the key programmed as [Activity Detection] to Activity
Detection On and Off . If an event occurs while Activity Detection
is enabled, for instance, if the transceiver remains in the tilt
or stationary state or is excessively in motion longer than the
preconfi gured time, the transceiver enters Emergency Mode.
Note:
◆ When Activity Detection has been turned off , and the transceiver
power is then turned off and back on, Activity Detection is
automatically enabled.
◆ When using this function, verify that it operates before taking the
transceiver.
■ Activity Reset
While Activity Detection is active, press the key programmed
as [Activity Reset] to reset the Activity Detection
countdown timer. This will allow you to remain in a tilted
or stationary position, etc., Without the Emergency mode
activating unnecessarily.
SCRAMBLER/ ENCRYPTION
Press the key programmed as [Scrambler/ Encryption], or
access the Menu {Page12}, to switch the transceiver to secure
(encrypted) transmission.
• Pressing the PTT switch after the Scrambler function has been
turned ON encrypts the transmitted signal.
24