Zanussi ZBA23020SA User Manual page 28

Ventilation requirements
The airflow behind the ap-
pliance must be sufficient.
Installing the appliance
Caution! Make sure that the mains cable can move
freely.
Do the following steps:
x
1
If necessary cut the
adhesive sealing strip and
then apply it to the appli-
ance as shown in figure.
28
5 cm
min. 200cm
x
2
Install the appliance in
the niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture.
Push the appliance in the
direction of the arrows (2)
against the cupboard on
the opposite side of the
hinge.
2
4mm
min.
44mm
200cm
2
3
Adjust the appliance in
the niche.
Make sure that the dis-
tance between the appli-
ance and the cupboard
front-edge is 44 mm.
The lower hinge cover (in
the accessories bag)
makes sure that the dis-
tance between the appli-
ance and the kitchen furni-
2
ture is correct.
Make sure that the clear-
1
ance between the appli-
ance and the cupboard is
4 mm.
Open the door. Put the
lower hinge cover in posi-
tion.
5
Remove the correct
part from the hinge cover
(E). Make sure to remove
the part DX, in the case of
right hinge, SX in opposite
case.
I
I
4
Attach the appliance to
the niche with 4 screws.
C
D
E
E
6
Attach the covers (C,
D) to the lugs and the
hinge holes.
Attach the hinge covers (E)
to the hinge.