Hisense BabySense V35US User Manual page 12

Problem
Possible cause/solution
A high pitched
• The Baby Unit and Parent Unit may be
ear piercing
noise is heard
from the units
• The volume on the Parent Unit may be
(feedback, sta�c)
Cannot hear the
• Volume se�ng on the Parent Unit may
baby sounds on
the Parent Unit
• Ba�ery power may be too low.
Background
• In a quiet environment, surrounding
noises
• In a loud environment, surrounding the
Picture is black
• Automa�c Night vision mode may be on.
and white
• Lens is dirty. Follow the Maintenance
Lines/marks
across the
• Confirm that power adapters are
screen
• Restart the Baby Unit ( unplug the power
• Reset the Parent unit by disconnec�ng
The
• The power adapter may not be
rechargeable
ba�ery will not
• Ba�ery pack may not be properly
charge or no
charge light
shows
• Switch to another wall outlet.
too close to each other. Move them
further apart.
set too high. Lower volume.
be too low. Increase the volume.
Recharge the ba�ery.
the Parent Unit, decrease the volume on
your Parent Unit to level 3 and below.
Parent Unit, increase the volume to
the maximum level.
Turn on the room lights
to force monitor out of night vision mode.
procedure on page 10.
properly connected.
adapter from the wall outlet, wait for
approx. 5 seconds and plug it back into
the wall outlet).
(for 5 seconds) and reconnec�ng the
ba�ery pack.
properly connected.
connected inside the ba�ery
compartment. Disconnect and
reconnect the ba�ery pack.
12