This operating manual contains important information on the use, maintenance and safety of your Kemppi product. The technical specifications of the device can be found at the end of the manual. Please read the manual carefully before using the equipment for the first time. For your own safety and that of your working environment, pay particular attention to the safety instructions in the manual.
Power source connection The HF wire feeder is recommended to be used with the Kemppi HiArc power source, but it can be used with other power source brands as well. To connect the wire feeder to the power source, do the following: Attach the wire feeder interconnection cable to the plus connector of the power source.
USING THE MACHINE Machine introduction 3.1.1 Wire feeder front and side view HF 10E front HF 10P front EURO connector for welding gun 5. Panasonic connector for welding gun Amperage/WFS control knob 6. Connector for trigger wires of gun Voltage control knob 7.
The drive roll has two different sized grooves in it. You can choose which groove to use by opening the drive roll securing screw and turning the drive roll other way round. The size of the groove currently in use is facing outward. HF 10E, 10P...
The owner of the equipment is obliged to deliver a decommissioned unit to a regional collection centre, per the instructions of local authorities or a Kemppi representative. By applying this European Directive you will improve the environment and human health.