Advertisement
Table of Contents
Technical Manual for the
Horn - DB1PUL
DB1HP UL
Please note that every care has been taken to ensure the accuracy of our technical manual. We do not, however, accept
responsibility for damage, loss or expense resulting from any error or omission. We reserve the right to make alterations
in line with technical advances and industry standards.
© Eaton MEDC Ltd 2017
07/17
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for MEDC DB1PUL
Summary of Contents for MEDC DB1PUL
- Page 1 Please note that every care has been taken to ensure the accuracy of our technical manual. We do not, however, accept responsibility for damage, loss or expense resulting from any error or omission. We reserve the right to make alterations in line with technical advances and industry standards. © Eaton MEDC Ltd 2017 07/17...
-
Page 2: Installation
NEMA/IP rating of the unit is maintained. The unit is mounted via 2 x Ø 0.31” (8 mm) fixing holes in the base. The fixing holes have been designed to accept an M6 screw or bolt. MEDC recommend the use of stainless steel screws. -
Page 3: General Arrangement
GENERAL ARRANGEMENT 2 - HOLES " / 8mm " / 140mm FIXING CRS " / 79mm " / 175mm DIA " / 171mm DIA ALL DIMENSIONS IN INCHES AND MILLIMETERS © Eaton MEDC Ltd 2017 07/17... - Page 4 * DB1P Tone 4 is acceptable for ublic mode use. DB1P Tones 14 & 19 are acceptable for rivate mode use. DB1HP Tones 4 & 14 are acceptable for ublic mode use. DB1HP Tone 19 is acceptable for rivate mode use 07/17 © Eaton MEDC Ltd 2017...
-
Page 5: Operation
If a fault should occur, it is recommended that the unit be returned to MEDC for repair. All parts are replaceable. - Page 6 Sounder against the requirements of IEC 61508-2 using a Proof Test Interval of 8760hrs. The results are shown below and are based on Route 1 The Sounder is classed as a Type B device 07/17 © Eaton MEDC Ltd 2017...
- Page 7 Hardware safety integrity Route 1 compliance Systematic safety integrity Route 1 compliance Systematic Capability (SC1, SC2, SC3, SC4) Hardware safety integrity achieved Limited to: SIL 1 (1oo1) & SIL 2 (1oo2) due to SFF value. © Eaton MEDC Ltd 2017 07/17...
- Page 8 Eaton MEDC Ltd, Unit B, Sutton Parkway, Oddicroft Lane, Sutton in shfield, United Kingdom NG17 5FB Tel: +44 (0)1623 444444 Fax: +44 (0)1623 444531 MEDC Stock No: TM107-ISS.D...
Need help?
Do you have a question about the DB1PUL and is the answer not in the manual?
Questions and answers