ExpressPod EP02L-LITE-FS (touchless)
Assembly Instructions
You will need a small Phillips
screwdriver to assemble your
ExpressPod. A hex key is also
supplied in the packaging.
Secure the ExpressPod to the bracket
with the 4 x screws (screw B) provided.
Check the pod is the right way up.
Secure the base to the bottom of the
pole with 4 screws (screw A).
Please note, as this Pod has
touchless capacity, once it has been
switched on, be careful when
repositioning the Pod for example, to
avoid inadvertently pressing a
button.
Turn group feedback
into actionable insights
Locate the slider switch on the back of
your ExpressPod.
Slide the switch across so it's in the 'On'
position - the switch should be
positioned towards the red button.
Turn the stand the right way up and
secure the vesa bracket on the top of
the pole with the 4 screws provided
(screw A).
To get started,
please visit:
guide.ombea.com.