Epson B12B808393 Install Manual

Network image express interface card

Network Image Express Interface Card

This section explains how to install the optional Network Image Express interface

card (B12B808393) in your scanner.

Setting Up Client Computers

Before connecting the scanner to your network, make sure any computer you want to

use for scanning is set up properly. Check that:

an Ethernet network card is installed in the computer

the computer is configured to use the TCP/IP network protocol

your scanner software is installed (see the Start Here sheet for instructions)

For instructions on installing your computer's card, see the manual that came with

the card. For instructions on setting up TCP/IP, see your computer's manual or

online help.

1. Turn off the scanner and disconnect the power cord and any cables.

2. Remove the two screws securing the shield plate to the scanner's optional interface

slot, and then remove the plate. Keep the screws and shield plate in case you want

to reinstall them later.

3. Fully insert the Network Image Express card in the slot, and tighten its screws.

Caution: Do not insert the card with the scanner turned on, or you could damage

the card or the scanner.

Table of Contents

Do you have a question about the B12B808393 and is the answer not in the manual?

Page 1 Network Image Express Interface Card This section explains how to install the optional Network Image Express interface card (B12B808393) in your scanner. Setting Up Client Computers Before connecting the scanner to your network, make sure any computer you want to use for scanning is set up properly.
Page 2 4. Plug in the scanner and reconnect its cables. 5. Initialize the card by holding down its connector) while you turn on the scanner. Continue holding down the button for about 10 seconds, until the card’s red and green lights (to the left of the connector) turn on.