LG PSW400B Owner's Manual page 4

How to attach to masonry walls
2
- Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry
brick and hallow block that do not crack.
Please follow the below direction.
- Check the material of the wall and the thickness of the finishing.
- When installing the product on the wooden wall, refer to page 5.
- When installing the product on wall material not designated, install the product so that each fixated location
can withstand the pull out load of 70kgf (686N) and shear load of 10kgf (980N) or above.
a
d
- Use the Ø8mm drill bit for concrete and hammer (Impact) drill.
a. Use a drill bit Ø8mm to drill a hole for the anchor location within a depth of 80mm ~ 100mm
b. Clean the drilled hole.
c. Insert the sealed anchor to the hole. (When inserting the anchor, use a hammer.)
d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face upward.
e. Align the wall mount bolt to the hole and tighten it. At this time, the bolt must be tightened with torque of 45kgf/cm
or above.
3 How to install the wall mount
<When installing on a masonry wall>
→ When you separate the 8 screws on the wall mount connected to the wall bracket for use with a wooden wall,
it is much easier to install the product.
→ When installing the product on a masonry wall, turn
the 8 screws on the A part counterclockwise to
separate the screw and bracket.
→ After aligning the wall bracket to the location to
install, mark the part to screw on the wall and then
remove the wall bracket.
→ Refer to page 3 to attach the wall bracket.
→ Use a level to check whether the wall mount is level.
4
b
e
A
Separate the wall mount screw.
c
Wall mount screw
Wall mount screw
→ If the screw cannot be assembled in the designated location
inevitably, it can be assembled by rearranging to the closest
location. But, do not change 2 or more locations from the
designated spot.
→ Assemble the wall mount screw on 2 left and 2 right locations
on the top and 1 left and 1 right location on the bottom part.
→ At this time, use a "+" driver (Manual or motorized) or 8mm
wrench to tighten the screw so that the wall, wall bracket and
screw are completely pressed against one another.
Anchor