Youngman Adjusta-Minit User Manual

Adjusta-Minit
Adjustable Height
Mobile One Man Work Station
USER GUIDE
Safety First
IMPORTANT: Never use the work station until you have
fully read and understood this User Guide and the work
station has been properly set up using the information it
contains.
Stabiliser Platform height
adjustment foot
Safety Checklist
Is the workstation in good condition
(see Equipment Care & Inspection sections)
The total load (1 person plus tools & materials)
should not be more than 150kg
The 4 castors are pointing outwards and the
wheel brakes are locked
The guardrail is up and both diagonals are
locked
The work station is on flat, level, dry and firm
ground
The work station is correctly positioned to
avoid over reaching
The platform is at the correct height and the
foot pedal safety catch is locked
The stabilisers are fully extended and the
stabiliser locking handles are tight
The safety gate is shut and locked, once you
are on the platform
Equipment care
Every time, before you use the work station, carry out
the 6-point inspection detailed in the following section.
Never use the work station if any part is damaged or
shows signs of excessive wear. Only use this piece of
equipment for it's intended purpose, as a work station.
guardrail
Store the work station somewhere clean, dry and safe.
The work station may be stored in the raised or lowered
Platform
position.
Ladder Section
Keep the work station clean, especially the plywood
platform and the treads of the ladder section. This is
easier if you clean it regularly.
Do not use excessive force to operate the work station
mechanisms.
pedal
6 Point inspection procedure
1
Check all 4 castors are secure and the fixing
bolts are tightened correctly.
2
Check all 4 wheel brakes operate and lock
the wheel and the castor rotation.
3
Check the tubes and aluminium components
of the workstation. There should not be any cracks
or excessive dents or distortion.
4
Check there is free movement of the
telescopic base section and all the hinge
points of the work station.
5
Check the plywood platform. There should
not be excessive contamination, cracking, holes
or damage including any missing or damaged
rivet fixings.
6
Check the following work station locking
mechanisms are operating and locking correctly:
guardrail diagonal centre locks, guardrail safety
gate lock, foot pedal interlock, foot pedal safety
catch.
1 2