Probotix GX2525 Assembly Manual

Machine Stand Assembly Guide
Each Kit will include:
64 – M6 x 12mm Socket Cap Screws
64 – M6 T-nuts
16 – Corner Brackets
8 – M5 x 20mm Socket Cap Screws
5 – M5 Push in T-Nuts
5 – M5 x18mm Socket cap screws
16 – 5/16" - 18 x 1" Socket Cap Screw (24 if castors)
4 – Plastic end caps
8 – 60/60 Adapter plates (4 if castors)
4 – Leveling feet or casters(depending on which option chosen)
1 – MDF Shelf
12 – Aluminum Extrusions per kit. Please see chart below for corresponding sizes.
B
A
B
A 4x Legs (6060)
B Front/Back (3060)
C Top Sides (3060)
D Bottom Sides (3060)
All rails are mounted inside the legs flush to the outside, except for the C rails, which
mount to the outside. The B rails are front/back of the machine. The upper rails should
be flush with the top while the lower rails can be adjusted up and down as needed.
C
D
Extrusion Lengths (mm)
GX2525 GX3725
692 692
704 987
832 832
718 718
C
B
D
B
GX2550 GX3750
692 692
704 987
1528 1528
1414 1414