Flexeserve Nuttall Hub Quick Start Manual

Flexeserve Hub®
Operation
Heating
Each of the model variants are supplied with a mains power switch and a controller. The controls are located
behind the front panel at the top of Flexeserve Hub®.
Set the mains power switch to the 'I' position and the controller will illuminate. The display will show the
current temperature. The equipment will begin to heat and reach the established temperature set-point
automatically, generally 85°C (185°F). To switch off the unit, set the power switch to the 'OFF' position.
Adjusting Temperatures
To view the temperature of the unit, press the 'temperature' button for half a second, and then release. To
change the temperature of the unit, press and hold the 'temperature' button and press the arrow buttons to
increase (▲) or decrease (▼) the temperature. When the 'temperature' button is released, the new value is
stored.
FLEXESERVE® | Flexeserve Hub® Quick Start Guide | R5 APR 2021 | 40002983
Flexeserve® Customer Support
[t] +44 (0) 1455 638300
[e] customer.support@flexeserve.com
For full details on how to operate this equipment
safely, please refer to the Operation manual.
Power switch
I = On position
Temperature
O = Off position
WARNING
In an emergency, switch off the appliance and isolate
fully from the mains supply.
CAUTION
The internal surfaces will become hot, reaching
temperatures above 70°C (158°F).
Temperature
adjustment button
Controller display
Page | 1 of 2
